Cable type for NM-1T3/E3

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Fri, 07/31/2009 - 01:43
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

No it does not.


T3/E3 uses 75 Ohm cable with BNC connectos that you can make yourself or by any radio shop.

Wilson Samuel Fri, 07/31/2009 - 04:00
User Badges:
  • Gold, 750 points or more
  • Community Spotlight Award,

    Mobile User, July 2015

Hi Sat,


For NM-1T3/E3, there is no possibility (as far as I could check) of using E-1 cable. The E-1/T-1 cable could be (for VWICs) any RJ-45 UTP Cable, however for DS-3(or T3/E3) it has to be a coax.


http://www.cisco.com/en/US/prod/collateral/modules/ps2797/ps4909/product_data_sheet09186a008010fba2.html


HTH,


Kind Regards

Wilson Samuel

rigoel Tue, 08/04/2009 - 06:09
User Badges:
  • Cisco Employee,

Hi,


The Cisco T3/E3 Network Module provides direct connectivity to a T3 line for full-duplex

communications at the T3 rate of 44.736 MHz and full-duplex E3 communications at 34.368

MHz. Each T3 or E3 port consists of a pair of 75-ohm BNC coaxial connectors (Type RG-59),

one for transmit data and one for receive data, along with six LED indicators for line

status. The Cisco T3/E3 Network Module is supported in all Cisco IOS feature sets, and

there are no additional memory requirements.


Here is the reference link:

http://www.cisco.com/en/US/partner/products/hw/modules/ps2797/products_data_sheet09186a008

010fba2.html


Regards,

Rishika

Actions

This Discussion