cor list configuration

Unanswered Question
Jul 31st, 2009
User Badges:

Hello,

i am running a ccme and there are working call restrictions configured.I want to add an extension so that when i type 918 and 1 and the phone number of an office it will route the call to the office gateway (in another gateway) i typed the following commands but it is not working

dial-peer voice 1031 voip

corlist outgoing tel-sonema-filiales

description Appels BSIC Guinée Conakry

max-conn 1

destination-pattern 9181T

session target ipv4:10.10.3.6

codec g711ulaw

no vad


Any help

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Fri, 07/31/2009 - 11:59
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

What COR has to do with interoffice calls ?


You have to be more specific and mention in which sense it's not working.


Eg. the remote router will see a call coming for 918xxxxxxxx, you should strip some digits before it leaves the local router. Remember, voip DP doesn't do that automagically like a pots DP.

kolawole1 Fri, 07/31/2009 - 12:29
User Badges:

Thanks here is a working config, for eg when users want to call senegal they dial 904 and 1 AND IT works but i have not seen any digit stripping command in the config file.There is a new agency in another country i just need commands allowing me to dial 918 and 1 followed by their number to call them.That is what i want

Thanks



Attachment: 
paolo bevilacqua Fri, 07/31/2009 - 21:19
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Then digit stripping, or a proper destiona-pattern, is configured in the senegal router.


You have to do your troubleshooting as likely it's a matter do DP configuration, check "debug dialpeer" on both routers.

Actions

This Discussion