VPLS on 12000 series IOS

Unanswered Question
Giuseppe Larosa Sat, 08/01/2009 - 05:23
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Pramod,

GSR 12000 and ASR 1000 are routers:

commands have to applied to:

main interfaces or subinterfaces there are no SVIs here only L3 interfaces and subinterfaces.


Hope to help

Giuseppe


marikakis Mon, 08/03/2009 - 08:13
User Badges:
  • Gold, 750 points or more

An 'xconnect' command is not used when configuring VPLS on the GSR. Please have a look at the following document about configuring VPLS on the GSR:

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1038114


Also, you should probably have a look at the limitations/restrictions:

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1025005

and the supported ISE linecards and SPAs:

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1025011


The limitations/restrictions are plenty, so you probably need to test and/or contact cisco to address the requirements of your specific environment.


p.s. I can't help with the ASR 1000, but I think somebody replied to another conversation that you opened about this platform.

Actions

This Discussion