08-01-2009 03:37 AM - edited 03-04-2019 05:37 AM
How to configure vpls on 12000 series. i can able to create l2 vfi name manual etc
how to apply on vlan interface.I didnt see int vlan command to apply xconnect vfi . please help.The same issue on ASR 1004 also
08-01-2009 05:23 AM
Hello Pramod,
GSR 12000 and ASR 1000 are routers:
commands have to applied to:
main interfaces or subinterfaces there are no SVIs here only L3 interfaces and subinterfaces.
Hope to help
Giuseppe
08-02-2009 07:45 PM
Hi Giuseppe,
But i didn't find command xconnect vfi command on subinterface/maininterface of router
08-03-2009 08:13 AM
An 'xconnect' command is not used when configuring VPLS on the GSR. Please have a look at the following document about configuring VPLS on the GSR:
http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1038114
Also, you should probably have a look at the limitations/restrictions:
http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1025005
and the supported ISE linecards and SPAs:
http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/vpls_qos.html#wp1025011
The limitations/restrictions are plenty, so you probably need to test and/or contact cisco to address the requirements of your specific environment.
p.s. I can't help with the ASR 1000, but I think somebody replied to another conversation that you opened about this platform.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: