WLC 4402-12 to support more then 12 AP's

Unanswered Question
Aug 1st, 2009

We have a WLC 4402-12 that support up to 12 AP's. Can I upgrade this WLC to support more then 12 AP's?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Robert.N.Barrett_2 Sat, 08/01/2009 - 05:08

I don't believe you can upgrade your existing hardware. You may be able to arrange a trade-in, though.

You could always get another 4402-12 and put them in the same mobility group.

George Stefanick Sat, 08/01/2009 - 05:31

You can not upgrade the 4402-12 appliance to handle additional access points above the 12. The 12 is hard set.

The new 5500's are going to be allow different ap counts via a license.

n.vd.coevering Sat, 08/01/2009 - 08:31

OK, thanks. Then hopefuly there is a trade-in possiblity. Adding another 4402-12 is more expensive.

Lucien Avramov Sat, 08/01/2009 - 13:01

The 2106 lets you add another 6 AP and should be less expensive than the 4402-12. You may be able to trade it in if it's within 90 days, check with your account team.

Depending on what design you have you might also consider autonomous access-points.

Leo Laohoo Sat, 08/01/2009 - 18:16

Don't worry. You can ideally use the WLC4402-12 in a lab environment.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode