Source Based ROuting

Unanswered Question
Aug 2nd, 2009
User Badges:

Hii,


Kindly tell me about IP source based routing in cisco (router/L3 switches). How to check the status of IP source based routing on router (if enabled or diabled).


PLease share the command to disable IP SOURCE based routing on cisco device.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ivarnhagen Sun, 08/02/2009 - 02:34
User Badges:

Hi,


you can find information about policy routing (routing based on configured policies, incl. source IP) here:


http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a008009481d.shtml


http://www.cisco.com/en/US/docs/ios/12_2/qos/configuration/guide/qcfpbr_ps1835_TSD_Products_Configuration_Guide_Chapter.html


http://www.petri.co.il/how-to-use-cisco-ios-policy-based-routing-features.htm


PBR is not configured by default. To disable an existing PBR configuration, remove the route map from the interface. To keep the config clean, you would also want to remove the other related commands.


Please rate if this helps.

paolo bevilacqua Sun, 08/02/2009 - 02:37
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

no ip source-route

Actions

This Discussion