08-02-2009 08:44 AM - edited 03-18-2019 11:27 PM
I have Unity 5.0 Build 5.0(1) and bulk edit 4.0 build 115.
When I use the password tab to reset a range of users passwords they are not changed correctly. I have set a users password to a default of 2222 using SA and verified it was correct by logging in via the TUI. I then ran the bulk edit tool and changed this users password to 3333. Now neither password works.
Any suggestions?
08-11-2009 01:55 PM
Tom,
you might be hitting this defect -
CSCsr02403 Using BulkEdit tool to change password results in blank password
Symptoms:
Password is blank after changing it via BulkEdit tool
Conditions:
This problem may occur in Unity 4.2(1) and Unity 5.0(1).
The issue is fixed in Unity 7.0(2) and later.
Workaround:
You can manually set the password via SAWeb
Or, to use Bulk Edit but avoid the defect, perform the following before running Bulk Edit.
Open a command prompt (DOS) and go to \CommServer\components
The type in the following commands;
Regsvr32 /u BabelSvr.dll
Regsvr32 BabelSvr.dll
08-20-2009 04:39 PM
Thank you. That fixed my issue.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: