08-02-2009 08:56 AM - edited 03-06-2019 07:03 AM
When I associate a interface vlan of a Cat6509 to a bridge-group, local switch cannot see through hsrp the partnet switch. Bridge-group is neccessary because we need dlsw+.
08-04-2009 08:53 AM
Can you post the relevant parts of the config?
HTH,
John
08-04-2009 10:37 PM
Here you have the config:
dlsw remote-peer 0 tcp 10.33.1.4
dlsw icannotreach sap AA E0 F0
dlsw bridge-group 1
dlsw udp-disable
int vlan 28
bridge-group 1
bridge 1 protocol vlan-bridge
bridge 1 priority 20000
RSDCPD1#sh standby vlan 28
Vlan28 - Group 28
Local state is Active, priority 100, may preempt
Hellotime 1 sec, holdtime 3 sec
Next hello sent in 0.899
Virtual IP address is 180.165.28.1 configured
Active router is local
Standby router is unknown
Virtual mac address is 0000.0c07.ac1c
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: