08-02-2009 06:09 PM - edited 03-06-2019 07:03 AM
I currently have a Cisco 3750 switch as a standalone switch. The stsandalone switch is configured in a cluster e.g.
cluster enable MYCLUSTER 0
cluster member 1 mac-address 000f.900b.5920
cluster member 2 mac-address 000f.f70c.3580
cluster member 3 mac-address 000f.f779.9140
I am going to add another 3750 switch to the network but I am going to connect the 3750 to the existing 3750 using the stack cables and configure the existing switch as the stack master.
Is this likely to impact on the configuration of the cluster?
Many thanks
08-02-2009 06:53 PM
Don't configure anything on the new 3750.
Connect the Stack cable BEFORE powering up the new switch. The new switch will copy or share the configuration from the stack master.
Just make sure the new switch has the same IOS as the Stack master.
Hope this helps.
08-02-2009 07:05 PM
Take a look at provisioning the switch before installing.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: