AP Migration in WCS: "Failure - Veryfying Radio role"

Answered Question
Aug 3rd, 2009
User Badges:

Hi,

while trying to convert autonomous APs (AIR-AP1121G-E-K9) to LWAPP mode WCS always says "Failure - Veryfying Radio role". Does anybody know why this occurs? The migration analysis summary shows all criteria as green. Thanks.

Correct Answer by Lucien Avramov about 7 years 7 months ago

In the logs folder of wcs: /wcs/webnms/logs/ there should be a direction for migration and logs from the migration of that ap.


Would you mind posting it?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
Lucien Avramov Tue, 08/04/2009 - 20:55
User Badges:
  • Red, 2250 points or more

You probably dont have both radios in root mode:


dot11Radio 0

station-role root

shut

!

dot11Radio 1

station-role non-root bridge

shut



You should have :


dot11Radio 0

station-role root

shut

!

dot11Radio 1

station-role root

shut


You may have to reboot the ap after that to get it to work

f.wossal Tue, 08/04/2009 - 23:41
User Badges:

Thanks for your fast answer.

The problem still occurs.

I only have one radio (dot11Radio0) which is shutdown and the station-role is root:


!

interface Dot11Radio0

no ip address

no ip route-cache

shutdown

!

encryption vlan 176 mode ciphers aes-ccm tkip

!

broadcast-key vlan 176 change 600 membership-termination capability-change

!

!

ssid (...)

!

mbssid

speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0

station-role root

rts threshold 2312

bridge-group 1

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

!


Correct Answer
Lucien Avramov Wed, 08/05/2009 - 09:09
User Badges:
  • Red, 2250 points or more

In the logs folder of wcs: /wcs/webnms/logs/ there should be a direction for migration and logs from the migration of that ap.


Would you mind posting it?

f.wossal Thu, 08/06/2009 - 04:54
User Badges:

Hi, I found the problem. The WCS had problems establishing a telnet session to controller. I solved it, now it works. Thanks for your help.

Actions

This Discussion