IPM and ICMP Jitter

Answered Question
Aug 5th, 2009

hi,

how to configure IPM for icmp jitters.

can i configure the same for my lan devices and critcal links.

I have this problem too.
0 votes
Correct Answer by Matej Gololicic about 7 years 3 months ago

You have to configure source and target device (must have responder functionality enabled). Then you configure type of monitor and time frame (by time frame I mean if it is Real-time, or historical). Just follow the steps.

Then you wait a bit and results should show in IPM tab.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Matej Gololicic Wed, 08/05/2009 - 03:56

Hi!

You have to enable responder functionality on devices you are trying to monitor.

Correct Answer
Matej Gololicic Wed, 08/05/2009 - 04:18

You have to configure source and target device (must have responder functionality enabled). Then you configure type of monitor and time frame (by time frame I mean if it is Real-time, or historical). Just follow the steps.

Then you wait a bit and results should show in IPM tab.

Actions

This Discussion