08-05-2009 12:53 AM
hi,
how to configure IPM for icmp jitters.
can i configure the same for my lan devices and critcal links.
Solved! Go to Solution.
08-05-2009 04:18 AM
You have to configure source and target device (must have responder functionality enabled). Then you configure type of monitor and time frame (by time frame I mean if it is Real-time, or historical). Just follow the steps.
Then you wait a bit and results should show in IPM tab.
08-05-2009 03:56 AM
Hi!
You have to enable responder functionality on devices you are trying to monitor.
08-05-2009 04:05 AM
how to enable that. pl help.
will it enable on enabling the snmp traps.
08-05-2009 04:10 AM
conf term
ip sla responder
Which devices are you talking about?
08-05-2009 04:13 AM
cisco devices only. any other things that need to be configured.
08-05-2009 04:18 AM
You have to configure source and target device (must have responder functionality enabled). Then you configure type of monitor and time frame (by time frame I mean if it is Real-time, or historical). Just follow the steps.
Then you wait a bit and results should show in IPM tab.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: