Public Access IP Phones

Unanswered Question
Aug 5th, 2009
User Badges:

Greetings -


We are running CUCM v6.1 in a single-site topology. We have several "hot spots" where we need to place a wired public access phone (7911G).


My plan was to create a separate partition along with separate CSSs for these particular phones. Also, I was planning on creating separate route patterns so that I could implement FAC for these particular phones.


Just wondering if I am going about this the correct way. Would there be something better in the way of implementing.


Any feedback would be appreciated. Thx.


Joe

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
islam.irshaid Wed, 08/05/2009 - 22:33
User Badges:

You are on the right way.

different separate Partition with separate CCS, and new route patterns with FAC codes.

j-shearer Fri, 08/07/2009 - 05:40
User Badges:

Thx for the clarification


I just wanted to make sure that I was going about it the right and that there was not a better or more efficient way of implementing.


Thx again.


Joe

Actions

This Discussion