connection between CME and Voice Gateway by using SIP

Unanswered Question
islam.irshaid Wed, 08/05/2009 - 22:44
User Badges:

Of course you can make a SIP trunk between CME and any Voice gateway supported sip.


you can use below Dail-Peer


------------------------------


Voice gateway Dial-peer

--------------------------------

dial-peer voice 400 voip

destination-pattern 2.T (CME pattterns)

session protocol sipv2

session target ipv4:"your CME IP address

codec g711ulaw

no vad


-----------------------------------

CME dial-peer

----------------------------------


dial-peer voice 4006 voip

destination-pattern 5.T (gateway Pattern

session protocol sipv2

session target ipv4:"Gateway IP"

codec g711ulaw

no vad



---------------



Hope this help you


if this help please rate

Actions

This Discussion