08-05-2009 10:03 PM - edited 03-13-2019 06:33 PM
Hi,
Does anyone know, Is there any way to setup a connection between CME and VOICE Gateway by using SIP ?
How is the configuration ??
For example
setup call from CME, will go to Voice Gateway by SIP
Thanks in advance
08-05-2009 10:44 PM
Of course you can make a SIP trunk between CME and any Voice gateway supported sip.
you can use below Dail-Peer
------------------------------
Voice gateway Dial-peer
--------------------------------
dial-peer voice 400 voip
destination-pattern 2.T (CME pattterns)
session protocol sipv2
session target ipv4:"your CME IP address
codec g711ulaw
no vad
-----------------------------------
CME dial-peer
----------------------------------
dial-peer voice 4006 voip
destination-pattern 5.T (gateway Pattern
session protocol sipv2
session target ipv4:"Gateway IP"
codec g711ulaw
no vad
---------------
Hope this help you
if this help please rate
08-05-2009 11:06 PM
Hi,
Thanks for the answer.
For my case
All the phones connected to CME
then when I dial prefix 8+number it will go to Voice Gateway by using SIP
in this case on the voice gateway we do need to setup anything as a SIP Server ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide