How to configure two CISCO VWIC-1MFT-E1ports into a single pipe

Unanswered Question
Aug 6th, 2009

hi friends,

how can i configure the two CISCO VWIC-1MFT-E1 ports into single channel group

serial interface.i need both ports to work as one data pipe.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
zeuscyril Thu, 08/06/2009 - 05:55


the above url giving the page you are searching is not available

Wilson Samuel Thu, 08/06/2009 - 05:37


Not sure if its E-1 PRI or E-1 (unframed/unframed) and the easiest way is to use PPP Multilink.

Here is one possible way to go for:

1. Make both the E-1 Interfaces use encap ppp

2. Create and Configure a Multilink Virtual Interface

3. Make the E-1 interfaces memeber of this Multilink Interface group.

And please find this as an example for the config

Above, all please let us know in case any help


Wilson Samuel

HTH, please rate if it helps


This Discussion