A colleague of mine has an old 1020 async router.
Needs to do password recovery per below Cisco doc.
Complete these steps in order to recover a password:
From the console, log in to the Cisco 1020 Router with user name enable and password override.
Note: If the enable password is not set, press Return at the password prompt.
The 1020 prints a challenge.
Provide the support representative with the challenge information.
The challenge is used to provide the response.
On the Cisco 1020 console, log in with user name enable and password response.
You are now in enable mode.
Here is the 1020 challenge = MOHOLPBMECCLFBSS
Could anyone provide the challenge response needed to access enable mode?