AP 521 after conversion from autonomous doesn't work

Unanswered Question
Aug 7th, 2009
User Badges:

I have buyed a WLC-526 and three AP521 AP. On the first AP521 I used the "Convert to LWAPP" tab in the configuration drawer, according Cisco procedure and after that I downloaded the c520-rcvk9w8-tar.124-10b.JX.tar image. After the procedure running, the AP521 goes in continous loop reload.

What's wrong? How can I recovery the initial image.

thanks an advance


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dancampb Fri, 08/07/2009 - 05:33
User Badges:
  • Cisco Employee,

Depends on how far the bootup is going. After the AP is converted to LWAPP it will keep rebooting if it can't find a controller to join.

eidoslanesi Fri, 08/07/2009 - 05:46
User Badges:

The WLC 526 is on the same subnet as APs.

martog Thanks


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode