08-07-2009 10:10 AM - edited 03-06-2019 07:08 AM
Hello,
Can anyone explain how PBR works on the Sup 6-E? I'm able to create a route-map with match and set conditions, however I can't apply it to an SVI or other L3 interface (ip policy route-map ...)
Can't seem to find any more online doc with any substance on this issue.
Here is an excerpt from the config guide:
The Catalyst 4500 Supervisor Engine 6-E supports matching route-map actions with a packet by installing entries in the TCAM that match the set of packets described by the ACLs in the match criteria of the route map. These TCAM entries point at adjacencies that either perform the necessary output actions or forward the packet to software if either hardware does not support the action or its resources are exhausted.
------------
Solved! Go to Solution.
08-07-2009 10:24 AM
You need 12.2(52)SG or later for PBR support on Sup6-E.
It's listed in the IOS Release Notes:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/release/note/OL_5184.html#wp1764194
HTH,
__
Edison.
08-07-2009 10:24 AM
You need 12.2(52)SG or later for PBR support on Sup6-E.
It's listed in the IOS Release Notes:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/release/note/OL_5184.html#wp1764194
HTH,
__
Edison.
08-12-2009 12:27 PM
Thanks Edison. 12.2(52)SG has PBR enabled.
I'm finding a lot of these small things that are missing for the Sup 6-E, but that's what ISSU is for!
08-12-2009 12:30 PM
Yes, Sup6-E has its issues :) Thanks for the rating.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: