cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
557
Views
0
Helpful
3
Replies

Conference calls in CME

JustForVoice_2
Level 4
Level 4

I have CME 7.1 and I need to implement conference calls up to 8 calls. So I added the following command:

max-conferences 8 gain -6

but I am not able to make conferences for more than 2 parties.

Shall I use conference bridge?

I have also the same problem with Music on hold, I used the command:

moh music-on-hold.au

but it does not work.

So any body can help me??

1 Accepted Solution

Accepted Solutions

Note, moh is sent to external calls only. And, .AU files good for the router are difficult to produce, so just try the default file to begin with.

Please remember to rate useful posts with the scrollbox below.

View solution in original post

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

You need to follow the conferencing chapter in the administration guide, the configuration is explained there.

thank you, but what about moh

I already have added the file (music-on-hold.au) to flash and under telephony service I added:

moh music-on-hold.au

but it does not work.

Note, moh is sent to external calls only. And, .AU files good for the router are difficult to produce, so just try the default file to begin with.

Please remember to rate useful posts with the scrollbox below.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: