cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
285
Views
0
Helpful
1
Replies

hwic-4esw for 2Mbps WAN lik

jay77jay77
Level 1
Level 1

I have this ongoing issues unresolved for somedays now. Got two sites connected by MetroE link and each side equipped with C2811 router witch HWIC-4ESW.

Under full load on the F0/0/0 port (load 253/255) im starting to see ping drops.Needless to say Fa0/0/0 is configured with vl100 to assign a WAN IP.

But under low traffic situation(load at 100/255), the ping are 100% success. But looking at sh int f0/0/0 im not seeing any packet drops on full load of 250/255

Another point to meniton,currently class based modular QoS with shaping is configured on the VLAN interfaces.

But same site before migration using WIC-1T, worked just fine even at full load of 254/255, without drops.

Is there anything interms of configuration...im missing here...any commands ..any sort of help is much appreciated.

Tks.

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Do not assume is router's fault. Maybe you SP is dropping the traffic.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card