Web Authentication - Web login page not displayed

BrianJ2007 · ‎08-09-2009

Cisco 4402 WLC running version 5.2.193.0

Access Points: AIR-LAP1142N

I have configured an SSID for WebAuthentication. When a wireless client logs into the WLAN the PC will associate to the AP but will then stop at the WEBAUTH_REQD stage.

Internet Explorer will show the attmept to redirect to the virtual port at 1.1.1.1 but will not bring up the login page.

IE shows : https://1.1.1.1/login.html?redirect=www.google.co.ukhttp://www.google.co.uk/

The network is a flat network so this SSID is using the management interface.

DHCP is being provided by the controller for this WLAN.

I know the classic design should be for this to be implemented on a separate VLAN but my customer has not VLANed his network yet and this is planned at a later stage. I have implemented this on a flat network before and it has worked.

Any suggestions would be much appreciated.

BrianJ2007 · ‎08-09-2009

Important bit of information left of the original entry.

Debug Client results in the following message for every attempt to log onto the WLAN:

Orphan Packet from 10.0.0.55 on mobile

Where 10.0.0.55 is the IP address of the laptop.

zhenningx · ‎08-09-2009

Can you client resolve DNS properly? If cannot resolve DNS, web auth page cannot load.

wg wireless · ‎08-13-2009

If the client is going through a proxy server, put virtual interface IP (eg. 1.1.1.1) in proxy exception of client LAN settings

harsisin · ‎10-27-2009

I faced exactly the same problem as you have described above. The following is what fixed it for me, i am sure u try it to might fix it for u as well.

In my scenario i found that my WLC controller had cipher-option sslv2 disabled. I enabled it and that resolved the issue for me.

This is what needs to be done in order to do it :-

It's best to enable it on the WLC and this is done from the CLI. It requires a reboot.

ssh to the WLC

enter the following command:-

WLC>config network secureweb cipher-option sslv2 enable

and then reboot.

Once the WLC reboots u can check the status by issuing the following command:-

WLC>show network summary

The output should look similar to the following

RF-Network Name............................. GTCR-CH-RF-GA

Web Mode.................................... Enable

Secure Web Mode............................. Enable

Secure Web Mode Cipher-Option High.......... Disable

Secure Web Mode Cipher-Option SSLv2......... Enable

As u can see the Secure Web Mode Cipher-Option SSLv2 is now enabled.

This should work.

Hope this helps and all the best.