Unanswered Question
Aug 10th, 2009

we have 7507 with redundant rsp & STM

we need to apply qos on serial int.

its not takeing command service-policy on serial int. even after enabling distributed cef .

can we apply dqos?

if so what is the procedure.

is there any document or configuration guide

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
brispin Fri, 08/14/2009 - 14:05

As of Cisco IOS Software Release 12.1(5)T, Quality of Service (QoS) policies must run in distributed mode on the VIP; Route Switch Processor (RSP)-based QoS is no longer supported. Thus, you must use the shape command and other commands of the Modular QoS Command-Line Interface (MQC) in order to implement Distributed Traffic Shaping (DTS) for Frame Relay interfaces on VIPs on the Cisco 7500 series. DTS combines Generic Traffic Shaping (GTS) and Frame Relay Traffic Shaping (Frame Relay TS).



This Discussion