×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Old overhead paging system

Unanswered Question
Aug 10th, 2009
User Badges:

Hello Netpro,


I have a client that wants to reuse his old overhead paging system. It's basically an amp with an RCA plug as input. How would I go about connecting it to their new IP Telephony setup? I was reading the cisco doc about using E&M interfaces, but I'm not sure how to interconnect the E&M interface to that RCA.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Tue, 08/11/2009 - 05:36
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Pablo,


You can use the Part below with an FXS port and it has an RCA connector output for connection to the Amp. This TAM-B is required in 99% of the cases I have seen.


Something like this;


http://www.camelectronics.com/botateacmo.html



Hope this helps!

Rob



Actions

This Discussion