cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
657
Views
0
Helpful
5
Replies

LMS 3.1 - IPM DefaultICMPJitter

DHARSH_01
Level 1
Level 1

For some reason when I set the DefaultICMPJitter collector I receieve an error "config failed" The other collectors configure fine. Any help is appreciated.

5 Replies 5

Joe Clarke
Cisco Employee
Cisco Employee

ICMP Jitter requires a source device running 12.4(6)T or higher. Is this the case? Do you have your SNMP read-write credentials properly configured on the device and in DCR?

I am running 12.4(13r)T. Yes, SNMP RW has been implemented. DCR has been verified with correct credentials.

This doesn't sound like a correct version. Please post the show ver from this device.

I check the core switch and the version is: Version 12.2(18)SXE1

Look like you answered my question.

Thank you.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco