cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
620
Views
0
Helpful
3
Replies

Port Utilization reports on LMS3.1

DHARSH_01
Level 1
Level 1

I am looking for a way to pull a report that will give me the port utilization % for each device. I have scrubed this application and to no avail. I am running LMS 3.1 on Windows. I have RME, DFM, IPM, Campus Manager all installed.

Can someone point me in the right direction?

Thank you

3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

You will need to install the Health and Utilization Monitor add-on. By default, you will get a 90-day of HUM. You can then configure an Interface Utilization poller for your devices which will provide you what you want.

Thank you jclark

I have Unified Operations Manager as well. I found a report that says VG utilization. But when I run the report, it only tells me the status of the VG's, not the utilization. Is there a way to get report port utilization from the OM on the Voice Gateways?

You should start a new thread for the OM question. I know OM tracks utilization, but it will not maintain a history as HUM will do.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco