Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1736
Views
0
Helpful
3
Replies

Caller ID over Qsig Problem + Nortel PBX + H323

karthi.sd
Level 1
Level 1

‎08-14-2009 03:23 AM - edited ‎03-15-2019 07:21 PM

hi,

my setup is like this

CUCM 7.x ->VGR(3845)H323 ->Nortel Pbx(QSIG)

E1 PRI is connected to Voice gateway router.A call handler is handling the call when a board number hits, then they will be landing on the extension dialed.

The cisco ip phones are displaying caller ID correctly if the calls are for cisco extensions.when a call comes for Nortel phones/extensions then its showing Voice mail port number instead of calling party ID.

Have changed the service parameter settings QSIG varaint to ECMA and h323 configurations like

h323

h225 display-ie ccm-compatible

isdn supp-service name calling profile Network-Extension operation-value-tag lo

cal

isdn outgoing ie facility

isdn outgoing ie extended-facility

isdn outgoing display-ie

isdn outgoing ie connected-number

isdn outgoing ie caller-number

isdn outgoing ie caller-subaddr

isdn outgoing ie called-number

But no luck.

Any help/suggestions are appreciated.

thanks

shiv

Labels:
0 Helpful
3 Replies 3

iptuser55
Level 6
Level 6

‎08-14-2009 03:47 AM

Hi,

I`ve tested this and there are some settings you need to set up like QSIG DECODE on the VG but can you explain the call flow what you mean by board number- Do you mean call from IPT to Nortel - OK but from Nortel to IPT - name fails?

thanks

0 Helpful

karthi.sd
Level 1
Level 1
In response to iptuser55

‎08-14-2009 04:58 AM

here is the call flow

when someone dials the board number xxxxxxxx (12345678)BSNL did number, greeting plays then the greeting request for extensions if they known.if they dial the extension of an user then the call lands on the destination phone.

In this case Nortel phones(Nortel phones are registered to Noterl passbook) are not displaying caller id which are connected via QSIG to Cisco voice gateway router(H323).

Have configured qsig decode under voice service viop but no luck.

thnks

shiv

0 Helpful

karthi.sd
Level 1
Level 1
In response to karthi.sd

‎08-14-2009 05:01 AM

One more info all CUG calls between Nortel and Cisco are working good and displaying caller id.

The problem comes when PSTN/outside calls are landing on Nortel phones via QSIG from VG through CUCM and Unity.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents