I need help for my dmvpn configuration. First i am sorry for my poor writing; I only speak a little English.
Straight to the point so:
I want to configure a dmvpn between 2 hubs (isr 2811) (one isp on each) and 1 spoke (in reality 13 but I only need to understand 1 configuration). The spoke (isr 1811) have 2 ISP (2 wan links).
The goal is that if a link failed on the spoke or on the hub, the private network behind the hub can still be reached by the private network behind the spoke.
The 2 hubs are on the same private network
I use eigrp as routing protocol. I can't use bgp.
For the moment only one tunnel comes up (between the spoke fa 1 and the hub1) and I can ping the hub lan network but if I cut off the hub 1, the tunnel go down and no other tunnel comes up â¦ if I cut off the spoke fa1 its strange, sometime a tunnel comes up and I can ping and sometime no.. (sa keepalive ?)
For those who are accustomed with dmvpn, does a configuration between dual hub and DUAL WAN spoke have a chance to work? What are my mistakes in my configuration?
If some of you have sample with a dual-wan spoke dmvpn It would be a great help.
Thank for your time and advice.