outbound voice call loadbalancing on multiple PRI

Answered Question
Aug 17th, 2009
User Badges:

Pls help i am currently having three PRI in h.323 setup on single gateway and CUCM 6.1.How can i loadbalance oubound voice calls on all the three PRI.If any sample config available pls share.

Correct Answer by Jaime Valencia about 7 years 8 months ago

Configure a route group with Distribution Algorithm = Circular


HTH


java


if this helps, please rate

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
paolo bevilacqua Mon, 08/17/2009 - 04:23
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Under controller, put them in a trunk group with a name of your choice.


Reference said trunk group under pots DP instead of port.


You can also configure hunt schemes under trunk group configuration mode.

paolo bevilacqua Mon, 08/17/2009 - 07:29
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You are welcome, please remember to rate useful posts with the scrollbox below.

ajay-pawar Mon, 08/17/2009 - 05:37
User Badges:

Hi can u pls suggest in case of MGCP how we can configure it on CUCM..

Correct Answer
Jaime Valencia Mon, 08/17/2009 - 05:40
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

Configure a route group with Distribution Algorithm = Circular


HTH


java


if this helps, please rate

ajay-pawar Thu, 08/20/2009 - 21:52
User Badges:

Thanks for the solution.I am facing another problem pls help .


How to configure load balacing with CUCM in gateway.

For example: Suppose I have dial-pattern x.x.x.x and three CallManager Pub,sub1 & sub2 in this case I have to configure preference in each dial-peer to select the

CallManager for incoming calls from PSTN on gateway.

In above configuration next CallManger is used only when first CallManager is not available.

Is there any way to configure so that first incoming call will go to first CUCM,2nd call will go to 2nd CUCM and so on

Actions

This Discussion