Solved: outbound voice call loadbalancing on multiple PRI

ajay-pawar · ‎08-17-2009

Pls help i am currently having three PRI in h.323 setup on single gateway and CUCM 6.1.How can i loadbalance oubound voice calls on all the three PRI.If any sample config available pls share.

Jaime Valencia · ‎08-17-2009

Configure a route group with Distribution Algorithm = Circular

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

View solution in original post

paolo bevilacqua · ‎08-17-2009

Under controller, put them in a trunk group with a name of your choice.

Reference said trunk group under pots DP instead of port.

You can also configure hunt schemes under trunk group configuration mode.

ajay-pawar · ‎08-17-2009

Thanks for the solution..

paolo bevilacqua · ‎08-17-2009

You are welcome, please remember to rate useful posts with the scrollbox below.

ajay-pawar · ‎08-17-2009

Hi can u pls suggest in case of MGCP how we can configure it on CUCM..

Jaime Valencia · ‎08-17-2009

Configure a route group with Distribution Algorithm = Circular

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

ajay-pawar · ‎08-20-2009

Thanks for the solution.I am facing another problem pls help .

How to configure load balacing with CUCM in gateway.

For example: Suppose I have dial-pattern x.x.x.x and three CallManager Pub,sub1 & sub2 in this case I have to configure preference in each dial-peer to select the

CallManager for incoming calls from PSTN on gateway.

In above configuration next CallManger is used only when first CallManager is not available.

Is there any way to configure so that first incoming call will go to first CUCM,2nd call will go to 2nd CUCM and so on