Telnet using source IP address

Answered Question
Aug 17th, 2009

Dear Experts,

Is there any way I can TELNET using the source IP address. I am aware of the

command

"telnet 192.168.1.1 /source-interface fastethernet 0"

But Here in this command I am able to specify only the Interface and not the

IP Address. Why i raised this point is, I am trying to TELNET a remote host

using my secondary IP address of the Interface.

Thanks in advance

sairam

I have this problem too.
0 votes
Correct Answer by somsh about 7 years 5 months ago

hi mate,

It is possible , try this command :)

telnet 10.10.10.1 /source-interface fastEthernet 0/1 /route:(Ip )

Cheers

Som

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Richard Burts Mon, 08/17/2009 - 03:49

sairam

I am not aware of any way in IOS to telnet and to source the telnet packets from a secondary address. When an IOS router generates a packet (including generating a telnet packet) the default is to use the primary address as the source and I am not aware of any way to change this behavior.

HTH

Rick

Correct Answer
somsh Mon, 08/17/2009 - 07:36

hi mate,

It is possible , try this command :)

telnet 10.10.10.1 /source-interface fastEthernet 0/1 /route:(Ip )

Cheers

Som

snarayanaraju Mon, 08/17/2009 - 09:19

Hi,

Have you gone thru the link. I am not able to understand or interpret the way he made the ACL to do Source TELNET

Thanks in advance

sairam

Actions

This Discussion