Cisco LMS and IDSM

Unanswered Question
Aug 17th, 2009
User Badges:

Hello,


I can ssh from the CiscoWorks server into IDSM device. But when I 'Check Device Credential' thru device center, it is blank against ssh and 'Did not Try' for Enable By ssh.


Doing ssh into IDSM takes directly into the privileged mode.


Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tech_trac Mon, 08/17/2009 - 05:56
User Badges:

It is not only management. LMS provides a suite of features. And IDSM is supported by LMS. It is listed when device is added via the DCR (Common Services).


I would like to use the feature provided by LMS for IDSMs


Thanks.

tech_trac Mon, 08/17/2009 - 06:44
User Badges:

Ok.


If I go to the CiscoWorks LMS Portal, click Device Management under Common Services, and then click Add, and then expand Cisco Interfaces and Modules, and click Cisco Services Modules I can see the following two devices


1. Cisco Catalyst 6500 Series Intrusion Detection System (IDSM-2) Services Module


2. Cisco Catalyst 6500 Series Intrusion Detection System (IDSM-2) Services Module Virtual Sensor


and I can successfully add the device as well. Also, I can see the added IDSM devices in RME and DFM etc as well.


What does this mean then ?


Thanks.


Lucien Avramov Mon, 08/17/2009 - 09:16
User Badges:
  • Red, 2250 points or more

Those devices are added in DCR for CSM to use them.

LMS can not provide you with monitoring for the IDS blades.


The support list for LMS has been made for this purpose: to list the devices that are supported.


tech_trac Mon, 08/17/2009 - 09:24
User Badges:


So even if they are listed in DFM and RME due to adding into the DCR, would it not provide any additional features ?


Thanks.

tech_trac Mon, 08/17/2009 - 21:51
User Badges:

Hello,


I am still having problems while detecting IDSM over ssh through DCR.


I can ssh from the CiscoWorks server into IDSM device. But when I 'Check Device Credential' thru device center, it is blank against ssh and 'Did not Try' for Enable By ssh.


Please assist.


Thanks.

Lucien Avramov Mon, 08/17/2009 - 22:31
User Badges:
  • Red, 2250 points or more

Lms supports the devices listed in the device support list.


Yes you will keep on having problems with trying to use a not supported device.


tech_trac Mon, 08/17/2009 - 22:47
User Badges:


I am only trying to add to the DCR (Common Services) where the device type - IDSM is shown. Shouldn't that be possible.


Thanks.

Actions

This Discussion