08-17-2009 12:28 PM - edited 03-06-2019 07:17 AM
Hi,
Do we have any command which show the
Interface name,IP address & subnet info at a time.
Thanks in advanced
08-17-2009 12:34 PM
show run | include interface | ip address
You might get some extra stuff though. There is no native command that I know of.
Hope that helps.
** you can add | exclude to remove the no ip address stuff-
show run | include interface | ip address | exclude no ip address
08-17-2009 12:35 PM
You can try show protocol, here is an example of the output.
Rack1R2#show protocols
Global values:
Internet Protocol routing is enabled
FastEthernet0/0 is up, line protocol is up
Internet address is 10.23.1.2/24
FastEthernet0/1 is administratively down, line protocol is down
Serial0/0/0 is up, line protocol is up
Serial0/0/0.203 is up, line protocol is up
Internet address is 10.2.2.2/24
Serial0/1/0 is administratively down, line protocol is down
Loopback0 is up, line protocol is up
Internet address is 10.22.0.2/24
HTH,
jerry
08-17-2009 12:41 PM
Hey Jerry,
I like that one especially when you | exclude down. Good one and worth some points.
08-17-2009 12:44 PM
Thank you Collin.
Regards,
jerry
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: