I have a HP C class blade enclosure, with 2 new 9124e's in it. I need to activate it,and figure on doing the following:
Define 2 T ports on the 9124e, and connect them, to 2 Fx ports on the 9509.(1 9124 to each 9509 for redundancy)
Here are my questions:
1) I am thinking that once the ports are connected and activated, the 9509 will propogate the existing config over to the 9124e, and I will modify the zone defs copied into the 9124e, and then activate the zoneset in the 9124e. Is that correct?
2) What happens when I activate the zone (zone 10 copied from 9509-1) in the new 9124e switch? Will it activate the zone in the 9509 also?
3) Since the 9124e has no Flash card, do I make the changes, copy the config to startup-config on the 9124e? will the changes be propogated to the 9509?
4) If the changes are copied to the 9509, do I login to the 9509, and copy the active config to the 9509's startup-config and flash drive?
Are there any other issues I am missing? Sorry for the questions, but any info will be a HUGE help.