08-18-2009 11:34 AM - edited 07-03-2021 05:57 PM
We are testing ACS 5 with Cisco and Juniper switches. Everything is working well, except we need to use a certain Juniper RADIUS attribute for downloadable filters (think downloadable ACL). The attribute is not listed in the ACS -> Config -> Dictionaries -> Protocols -> RADIUS -> Juniper section, and I cannot see a way of adding/editing the dictionary.
Any ideas?
08-19-2009 04:22 AM
I've also tested ACS5 a while ago with Cisco, HP, and other manufacturers...
Unfortuinaltely that's one of the points where ACS 5 is not yet mature...
Attribute addition is not yet supported, but will definitely be in roadmap.
There was an ask the expert event a few months ago about ACS5. You might want to take a look at that.
Best of luck
Gustavo Novais
08-19-2009 07:13 AM
I believe ACS 5.1 will have this feature, ACS 5.0 is limited in this regards. If this can not wait, you may use ACS 4.2
08-19-2009 12:48 PM
Thank you both for the replies. I'll check out the Ask the Expert, and I am now loading up ACS 4.2 eval to check it out. Looks like CSUtil.exe and I are going to get very chummy.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide