I have a point-to-point setup between the US and Holland. Both locations are running integrated VWIC2-1MFT-T1/E1. Both locations are using the line for clocking as directed by the carrier. I am seeing a high rate of crc, abort, and input errors on the Holland side. I am waiting to hear from the provider on the testing of the lines but I have been struggling to get this line fully operational. My fear is that they will come back and say it is an equipment problem but I have replaced all the cables and have used external CSUs with the same results. This is my first attempt at setting up a point-to-point across the pond but my research is pointing at timing for causing the errors and performance degradation. I have attached portions of the configs from both routers. Any help would be greatly appreciated.