08-21-2009 05:46 AM - edited 03-10-2019 04:39 PM
I have set up authentication and Authorization on the PIX. Authentication works but Authorization fails. I try to debug but nothing shows up (on PIX or ACS), but it does if I debug Authentication
Solved! Go to Solution.
08-21-2009 05:52 AM
Make sure you have enable authentication ,
aaa authentication ssh console TACACS LOCAL
aaa authentication telnet console TACACS LOCAL
aaa authentication enable console TACACS LOCAL
aaa authorization command TACACS LOCAL
Incase it does not work pls get aaa config
Regards,
~JG
Do rate helpful posts
08-21-2009 05:52 AM
Make sure you have enable authentication ,
aaa authentication ssh console TACACS LOCAL
aaa authentication telnet console TACACS LOCAL
aaa authentication enable console TACACS LOCAL
aaa authorization command TACACS LOCAL
Incase it does not work pls get aaa config
Regards,
~JG
Do rate helpful posts
08-21-2009 05:59 AM
-aaa authentication ssh console TACACS LOCAL
-aaa authorization command TACACS LOCAL
-aaa-server TACACS (inside) host [ip_address] [key] timeout 10
08-21-2009 07:40 AM
PIX\ASA command authorization does require enable authentication in the config.
You need to turn on enable authentication:
Here is the command
aaa authentication enable console TACACS LOCAL
HTH
Regards,
JK
08-21-2009 08:24 AM
Hi Lewis,
Pls add enable authentication command to make it work.
Regards
~JG
Do rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: