gig etherchannel on 6509 with 6148 module

Unanswered Question
Aug 24th, 2009

Can module 6148 with software 8.1(3) support gig etherchannel. I want to bind two ports for total of 2 gig. Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jbrenesj Mon, 08/24/2009 - 16:07

I will assume you have a WS-X6148-GE-TX card. Then:

The WS-X6548-GE-TX, WS-X6548V-GE-TX, WS-X6148-GE-TX, and

WS-X6148V-GE-TX modules have a limitation with EtherChannel.

EtherChannel is supported on these modules for all configurations (10,

100, and 1000 Mbps speeds) but be aware of these cases of

oversubscription when you configure these modules:

On these modules there is a single 1-Gigabit Ethernet

uplink from the port ASIC that supports eight ports. For EtherChannel,

the data from all links in a bundle goes to the port ASIC, even though

the data is destined for another link. This data consumes bandwidth in

the 1-Gigabit Ethernet link. For these modules, the sum total of all

data on an EtherChannel cannot exceed 1 Gigabit.

You receive a message on the maximum throughput when you

add a port of this module to EtherChannel.

C6500> (enable) set port channel 3/5,4/5 mode on

Adding a WS-X6148-GE-TX port to a channel limits the channel's

bandwidth to a maximum of 1Gig throughput

--------------------------------------------------------

The 1 Gig restriction is a hardware limitation on the WS-X6148-GE-TX. If you

want 8 GE ports at line rate, then you will need to use a WS-X6748-GE-TX

(which requires Sup720). The WS-X6148-GE-TX, WS-X6548-GE-TX and

WS-X6148A-GE-TX are all 8:1 oversubscribed, meaning you will get no more

than 6-Gbps of bandwidth from any one of those linecards.

From the CatOS 8.x Release Notes :

The WS-X6548-GE-TX, WS-X6548V-GE-TX, WS-X6148-GE-TX, and WS-X6148V-GE-TX

modules do not support the following:

­More than 1 Gbps of traffic per EtherChannel

********************************************** <<<<<<<<<<<<<<

Note With software release 8.2(1) [and newer], due to firmware enhancements,

the oversubscription problems associated with EtherChannel are no longer an

issue with the WS-X6548-GE-TX module.

********************************************** <<<<<<<<<<<<<<

This means that you can have let's say ports 1 and 9 on the WS-X6548-GE-TX working in a 2Gb channel after 8.2(1) or in IOS

Actions

This Discussion