Hello I'm wondering if anybody knows how to copy EEM Tcl settings from the active sup720 to the standby sup720.
I don't have much details at the moment as I have not viewed the problem myself, I've only heard about the problem.
I can only say that some settings(but not all) appear in the standby sup, when the settings are committed in the active sup.
The Tcl file is saved to disk0:
The event manager directory for user policies is set to point at disk0:
but the policy itself is not registered in the standby sup
I cannot reproduce. I have a 6506 with dial Sup 320s running 12.2(18)SXF11. I copied a simple policy, xxx.tcl to disk0:/policies and slavedisk0:/policies. I configured:
event manager directory user policy disk0:policies
I then registered the policy:
event manager policy xxx.tcl
As soon as I did a write mem, I saw the config sync to the slave. I then did:
hw-module module 6 reset
To failover to the hot standby module 5. I then did a show run on the switch (running on mod 5), and I see:
event manager policy xxx.tcl type user