simulator 2651

Unanswered Question
Aug 25th, 2009

Hi all

I have a question about C2651 Simulator.

this simulator is used for make a traffic.But I can not understand how to use at the below command.

Also, when I tried to configure something I saw the error message about my configuration.

simulator ss7 address sccp 10 pc 3000 ssn 8 route-on pcssn

simulator ss7 address sccp 11 pc 4000 ssn 8 route-on pcssn

simulator ss7 address sccp 100 ssn 1 route-on pcssn network national

simulator ss7 rlabel 0 slc * opc 3000 dpc 4000

simulator ss7 rlabel 1 slc 0 opc 4000 dpc 3000

simulator ss7 rlabel 2 slc 1 opc 4000 dpc 3000

1(config)#simulator ss7 rlabel 11 slc ?

* ignore slc <-what does mane?

<0-255> slc(in case of ITU vaild range is 0-15)

SIM2#$ mtp3 sccp 10 rlabel 0 priority 0 rate 1 total-packet 10000 instance 0

SIM2#

1d04h: SS7SIM : Error : Not all fields specified, in rlabel 0

=> the main issue is why rlabel could not working ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion