WAN with PPTP on RV082

info · ‎08-25-2009

Hi!

I have 2 WAN connections, both with pptp connection.

Linksys RV082

Firmware version : 2.0.0.19-tm (Feb 20 2009 15:15:20)

CPU : Intel IXP425-533

DRAM : 32M

Flash : 16M

rv082 don't connect to vpn servers (windows 2003 based), systemlog looks like:

Aug 25 17:10:23 2009	System Log	[ppp200] : Connection down !
Aug 25 17:10:23 2009	System Log	[ppp200] : ip 192.168.0.79 mask 255.255.255.255 remote 192.168.0.77 gateway 192.168.0.77 flag 0x10 metric 40 mtu 1400 dns1 192.168.0.11 dns2 0.0.0.0
Aug 25 17:10:23 2009	System Log	[ppp200] : Connection up !

does it normally?

wichilds · ‎08-25-2009

What are you trying to accomplish? Are you trying to use Quick VPN client and 2 wan connections? Are your 2 wan connections working as the pptp server, or are they acting more like IPSEC tunnels to other routers? Need more details about your setup and needs.

Bill

info · ‎08-25-2009

I try to connect to ISP, which require pptp connection through WAN link to his VPN server.

rv082 break connection immediately as I wrote, but if I replace rv082 with PC, it hold connection with the same settings.

picture attached.

wichilds · ‎08-25-2009

What is the service (cable, dsl, etc.) on the pptp connection side? This sounds like it could be an mtu issue.

info · ‎08-26-2009

100Mbit ethernet:

VPN server -> ethernet switch->WAN port RV082

i try manual 1300, 1400,1500 MTU, auto MTU - same results

wichilds · ‎09-02-2009

I do not have the equipment necessary to replicate your issue. The only recommendation I can make is to contact the small business support center for your country and do some troubleshooting with an STAC engineer. You can find the number here.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

You will need the model and serial number when you call.

Good Luck,

Bill