08-25-2009 07:06 AM - edited 03-06-2019 07:24 AM
Hi, if I need to clear all configuration on my 4507 (but leave the existing IOS on flash OK, I am planning to get to console on each supervisor and do:
Switch#write erase
then reload it.
Is that all or anything special I need to do when dealing with the supervisor engine?
08-25-2009 07:17 AM
That will wipe out any config minus anything that is in the vlan.dat file .
08-25-2009 07:27 AM
I did 'write erase' and I see that vlan information was wiped out. I just see a vlan 20 and obviously vlan 1.
08-25-2009 07:46 AM
Right if it had wiped out everything you would not see a vlan 20 . The main config is wiped out but the vlan info in the vlan.dat is there . I would just manually get rid of vlan 20 .
conf t
no vlan 20
08-25-2009 07:49 AM
Actually that may not be correct. It sounds vlan got wiped out by configuration on the first supervisor...
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: