08-25-2009 07:34 AM - edited 03-06-2019 07:24 AM
I have a 2960 that is connected to a NetGear router for cable modem access. The netgear gives out IP addresses. I have a WAP with two SSIDs. One ID is PUBLIC and tagged as VLAN 8. The other is PRIVATE and untagged. I can get the untagged SID to connect and get IPs from the netgear. I can get the tagged SID to connect to the WAP, but not getting IPs. I am not sure how to configure the ports on the 2960.
08-25-2009 07:44 AM
Are you trunking from the 2960 to the netgear ? Is the netgear router capabale of trunking and supporting dhcp from multiple subnets ?
08-25-2009 07:46 AM
I have the port that the Netgear and WAP on set to "switchport mode trunk".
08-26-2009 04:31 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: