VLAN with diferent gateway.

Unanswered Question
Aug 26th, 2009


I have three VLAN's configured in a C3560 Software (C3560-IPBASEK9-M), data, voice and WAN.

The WAN VLAN has two routers connected, I need to know how I can send voice traffic by one router and data traffic by another router, do you know how I can do it?.

Can I do it with this IOS?.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
luisveraza Wed, 08/26/2009 - 07:58

Ok, thank you.

I got the IP services software, do you have the procedure for updating it ?.

Thank you !.

Jon Marshall Wed, 08/26/2009 - 08:09


If you are running IP Services on your 3560 then it already supports PBR. You will however need to enable the SDM routing template ie.

3560(config)# sdm routing prefer


luisveraza Wed, 08/26/2009 - 08:17

No, I have: Image Name c3560-ipbasek9-mz.122-40.SE.bin.

But I got: c3560-ipservicesk9-mz.122-40.SE.bin

So I need to know how to upgrade it ?.

luisveraza Wed, 08/26/2009 - 09:39

Thank you by your support.

The procedure shows the next command:

archive download-sw /allow-feature-upgrade /overwrite /reload tftp:[[//location]/directory]/image-name.tar

I have an Bin file, I don't have the tar file.

Do you know If I can use this command with this Bin file?.

Thank you, best regards.

luisveraza Wed, 08/26/2009 - 08:18

I found it:

¨¨¨The Cisco Catalyst 3560 is available with either the IP Base or IP Services software images. The IP Base software includes advanced QoS, rate-limiting, ACLs, and basic routing and IPv6 functionality.

The IP Services software provides a richer set of enterprise-class features, including advanced hardware-based IP unicast and IP Multicast routing as well as policy-based routing (PBR)¨¨¨.

So, I need to upgrade to IP Services software.


This Discussion