cBarge to a VG248 line

Unanswered Question
Aug 26th, 2009

CUCM 7.0: I have an analog phone connected to a VG248 gateway, and I have this line shared on an IP phone. When initiating a cbarge from the IP phone into an active call on the VG248 line I am getting a dial tone.

Cbarge works for me between 2 IP phones with bridge ON and privacy OFF, but it doesn't work with the VG248 line (which doesn't have an option for bridge & privacy in the configuration page). The document below says that cBarge should work with VG248's (release 1.3.1).

Any suggestions are appreciated.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (1 ratings)


This Discussion