cucimoc deskphone mode

Answered Question
Aug 26th, 2009
User Badges:

I'm aware in cucimoc softphone mode we have telephony presence.


I'm trying to understand how or if telephony presence is provided in cucimoc deskphone mode ?

Correct Answer by htluo about 7 years 11 months ago

To set up desk phone mode, you need to associate the desk phone to end user (CUCM > User Management > End user). And you need to put the user into "Standard CTI Enabled" group.


On the client, nothing needs to be defined. After you logged in, CUCIMOC will retrieve a list of desk phone associated with your user ID and allows you pick one to control.


Michael

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
htluo Wed, 08/26/2009 - 19:27
User Badges:
  • Red, 2250 points or more

In short, it's provided by CUCM.


What other details you'd like to know?


Thanks!

Michael

nstathak Wed, 08/26/2009 - 20:03
User Badges:

how is this done, does it use CTI from cucm to cucimoc ? or some other protocol ?

htluo Thu, 08/27/2009 - 04:27
User Badges:
  • Red, 2250 points or more

It uses CTI to do phone control. It uses SIP for phone presence.


Michael

nstathak Thu, 08/27/2009 - 16:04
User Badges:

So if it utilises SIP then this device needs to be registered on CUCM ?


By creating this CSF device would it not consume a DLU ? or am I missing something

htluo Thu, 08/27/2009 - 17:34
User Badges:
  • Red, 2250 points or more

Please don't confuse SIP with "SIP phone".


Presence was achieved by SIMPLE (Session Initiation Protocol for Instant Messaging and Presence Leveraging Extensions), which does not consume DLU at all. SIP client SUBSCRIBE to CUCM on the DN. Whenever the DN status changed, CUCM will send NOTIFY to client.


CSF device would consume DLUs, because it's a phone device.


Michael

nstathak Thu, 08/27/2009 - 17:48
User Badges:

so what do you need to do on cucm to set it up in deskphone mode ?


also on the client, what needs to defined ?


appreciate your feedback it's getting much clearler

Correct Answer
htluo Thu, 08/27/2009 - 18:38
User Badges:
  • Red, 2250 points or more

To set up desk phone mode, you need to associate the desk phone to end user (CUCM > User Management > End user). And you need to put the user into "Standard CTI Enabled" group.


On the client, nothing needs to be defined. After you logged in, CUCIMOC will retrieve a list of desk phone associated with your user ID and allows you pick one to control.


Michael

j.house Mon, 08/31/2009 - 10:41
User Badges:

Is CUCIMOC supported with the R2 MOC client? I have installed, but my MOC interface is unchanged. I also read something that lead me to believe that CUCIMOC needs to have a phone built in CUCM for every user, this couldn't be the case could it?


Thanks

htluo Mon, 08/31/2009 - 13:10
User Badges:
  • Red, 2250 points or more

R2 is not supported yet.


A CSF device needs to be built on CUCM if want to use "full feature" of CUCIMOC.


Michael

Actions

This Discussion