Qos Verification on 6500

Unanswered Question
Aug 28th, 2009
User Badges:

Is there a command to verify the QOS markings and trust settings on a 6500? I am trying to verify if packets are being marked based on the trust settings. There is no external sniffer. Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Edison Ortiz Fri, 08/28/2009 - 12:47
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

You can capture this information with Netflow enabled globally in the switch and on the interfaces, then with the command show mls ip detail


Router# show mls ip detail


IP Destination IP Source Vlan Xtag L3-protocol Encapsulation


--------------+---------------+----+----+-----------+-------------+


RW-Vlan RW-MACSource RW-MACDestination Bytes Packets Age


-------+--------------+-----------------+-----------+-----------+-----+


Last Seen QoS Police Count Threshold Leak Drop Bucket


---------+-----------+------------+---------+-----------+----+-------+


Use-Tbl Use-Enble


+------+---------+




The TOS information will be shown in the output.


HTH,


__


Edison.

lesogorp11 Sun, 08/30/2009 - 07:54
User Badges:

Try this command "show mls qos ip" this will show policy-map/class-map attached and set/trust hits on each class-map. You can also just view an individual interface by using "show mls qos ip interface"


ex. show mls qos ip vlan 50

Actions

This Discussion