DHCP configuration writing issue on FWSM standby Unit

Unanswered Question
Aug 30th, 2009
User Badges:

Hi ,


We have FWSM module with multiple contex in active -active mode ,Have observed only DHCP configuration is not replicating from active to standby unit for two context .Same is happening for other context .we have five contex ,its happening for two context in same Failover group but not happing for other two in same failover group .

Please let me know is there any limitaion of issue with IOS .


IOS - FWSM Firewall Version 3.1(4) <system>

Device Manager Version 5.0(3)F


Compiled on Fri 08-Dec-06 16:55 by dalecki



failover cluster up 1 day 19 hours


Hardware: WS-SVC-FWM-1, 1024 MB RAM, CPU Pentium III 1000 MHz

Flash SMART CF @ 0xc321, 20MB


0: Int: Not licensed : irq 5

1: Int: Not licensed : irq 7

2: Int: Not licensed : irq 11


Licensed features for this platform:

Maximum Interfaces : 1000

Inside Hosts : Unlimited

Failover : Active/Active

VPN-DES : Enabled

VPN-3DES-AES : Enabled

Cut-through Proxy : Enabled

Guards : Enabled

URL Filtering : Enabled

Security Contexts : 20

GTP/GPRS : Disabled

VPN Peers : Unlimited


DHCP Config -


dhcpd address x.x.x.x -x.x.x.x inside

dhcpd dns x.x.x.x

dhcpd lease 3600

dhcpd ping_timeout 50

dhcpd enable inside


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion