Unanswered Question
Aug 31st, 2009

Dear All,

I'm unfamiliar and newbie to the VOIP system and need to setup small system for branch office.

I've just dug out a few related post from here (thank you netpro) and would like to ask a few question.

Here's the most similar example for my case.

please see the attach for sample diagram.

How can I configure for all international outgoing and incoming call ( with/without CUCM connection somewhere) in my router ?

Is it possible to configure all the call routing inside PBX ?

Please advise me how to set up in simplest way.

Thanks in advance

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Paolo Bevilacqua Mon, 08/31/2009 - 04:46

What is that you want to do in practice ?

If you're the endu user I recommend you locate a reputable cisco consulatant, because if you try this alone, you can semd a lot of time beforemaking it work 100% perfect.

yelynntun Mon, 08/31/2009 - 07:24

Thank you bevila,

I'm not going to do it for practise.

I'm quite familiar with IP routing and switching but not with the Voice traffic.

I need to set this up with PABX vendor and i'm afraid some sort of issue will arise.

yelynntun Mon, 08/31/2009 - 07:40

great, any kind help for the sample working configuration with international DID numbers ?

yelynntun Mon, 08/31/2009 - 07:56

let's say my telco assign 083 1234 500 to 083 1234 550 for my office.

How should I configure the dial peer for both outbound and inbound call ?

yelynntun Mon, 08/31/2009 - 08:07

i'm placing it on separate PBX.

Can it be done if the router is only connected to PBX and IP network ?

there's no direct PSTN connection to PBX nor router.

grazie paolo

Paolo Bevilacqua Mon, 08/31/2009 - 08:10

Yes, it can be done.

Again,please study a little when you have the router, what you want to do is not complicated but requires attention.


This Discussion