ONS 15305 with MGX 8800

Unanswered Question
Aug 31st, 2009
User Badges:

Hi,


I want to configure a Lab setup with Three ONS 15305 connected in SDH ring. Two MGX 8800 connected to ONS as provided in the diagram. ONS are connected via STM-1 and I want to connect the MGX with ONS via E1.


I wanted to know if this is a feasible solution.


I wanted to now the min configuration needed to have a talk between all of them. both the MGX confs and ONs confs.




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
viyuan700 Mon, 08/31/2009 - 05:42
User Badges:
  • Silver, 250 points or more

Yes the solution is feasible.


You have to create E1 crcuit in ONS from A to B.

Configure E1 card in MGX.


ONS dont have config like switch/router.

Check the link for ONS config guide


http://www.cisco.com/en/US/products/hw/optical/ps2001/products_configuration_guide_chapter09186a00808bdd85.html#wp1040823


You can check following links to see the config for MGX


http://www.cisco.com/en/US/products/hw/switches/ps1938/tsd_products_support_configure.html


Rajiv Dasmohapatra Tue, 09/01/2009 - 01:02
User Badges:

can i connect mgx and router / ONS and router via E1 with ATM encap.


how to go about it. an example or lik to example will be great.

viyuan700 Wed, 09/02/2009 - 10:19
User Badges:
  • Silver, 250 points or more

can i connect mgx and router / ONS and router via E1 with ATM encap.


SDH box (i.e E1 )is not concerned what protocol is going over it. if your both end routers have proper configs think should with ATM encap.

Rajiv Dasmohapatra Wed, 09/02/2009 - 10:38
User Badges:

what i meant was if some help regarding the configs for MGX / ONS could be found it would be a great help.

Actions

This Discussion